3Com 5500G-EI - poe max-power

96 CHAPTER 4: USING POWER OVER ETHERNET (POE) COMMANDS
View
System View
Parameter
None
Description
Use the poe legacy enable command to enable the nonstandard-PD detect
function.
Use the undo poe legacy enable command to disable the nonstandard-PD
detect function.
PDs compliant with 802.3af standards are called standard PDs.
By default, the nonstandard-PD detect function is disabled.
Example
Enable the nonstandard-PD detect function.
[SW5500]poe legacy enable
Legacy detection is enabled
Disable the nonstandard-PD detect function.
[SW5500]undo poe legacy enable
Legacy detection is disabled
poe max-power Syntax
poe max-power max-power
undo poe max-power
View
Ethernet Port View
Parameter
max-power: Maximum power distributed to the port, ranging from 1000 to
15400 mW.
Description
Use the poe max-power command to configure the maximum power that can be
supplied by current port.
Use the undo poe max-power command to restore the maximum power supplied
by current port to the default value.
By default, the maximum power that a port can supply is 15400 mW.