Routing Table Display Commands 147
3.3.3.0/24 DIRECT 0 0 3.3.3.1 Vlan-interface3
3.3.3.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
4.4.4.0/24 DIRECT 0 0 4.4.4.1 Vlan-interface4
4.4.4.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.0/8 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
display ip routing-table
acl
Syntax
display ip routing-table acl
acl_number
[ verbose ]
View
All views.
Parameters
acl_number
Enter the number of the IP ACL, in the range 2000 to 2999.
verbose Enter to display verbose information about both the active and inactive
routes that passed filtering rules. If you do not enter this parameter, the command
only displays a summary of the active routes that passed filtering rules.
Description
Use the display ip routing-table acl command to view the route filtered
through the specified ACL.
This command is used to display the routes that passed the filtering rules in the
specified ACL.
The command only displays routes that passed basic ACL filtering rules.
Example
To display a summary of the active routes filtered through basic ACL 2000, enter
the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]acl number 2000
[SW5500-acl-basic-2000]rule permit source 10.1.1.1 0.0.0.255
[SW5500-acl-basic-2000]rule deny source any
[SW5500-acl-basic-2000]display ip routing-table acl 2000
The information displays in the following format:
Table 17 Output Description of the display ip routing-table Command
Field Description
Destination/Mask Destination address/Mask length
Protocol Routing protocol
Pre Routing preference
Cost Cost
Interface Output interface, through which the data packet destined for the
destination network is sent
To Next Page
Loading...
