OSPF Configuration Commands 181
Example
To specify a default routing cost of 10 for an external route imported by OSPF,
enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf-1]default cost 10
default interval Syntax
default interval
seconds
undo default interval
View
OSPF View
Parameter
seconds
Enter the default interval, in seconds, for redistributing external routes.
This can be in the range 1 to 2147483647. The default is 1 second.
Description
Use the default interval command to configure the default interval for OSPF to
import external routes.
Use the undo default interval command to restore the default value of 1
second.
Because OSPF can import external routing information and broadcast it to the
entire autonomous system, and importing routes can affect the performances of
the device (depending on the number of external routes being imported), it is
necessary to specify the default interval for the protocol to import external routes.
Example
To specify a default interval of 10 seconds for OSPF to import external routes,
enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]router id 1.1.1.1
[SW5500]ospf
[SW5500-ospf-1]default interval 10
default limit Syntax
default limit
routes
undo default limit
View
OSPF View
To Next Page
Loading...
