Log Commands 473
By default, this function is enabled.
Example
Disable the terminal log display.
<SW5500>undo terminal logging
terminal monitor Syntax
terminal monitor
undo terminal monitor
View
User view
Parameter
None
Description
Use the terminal monitor command to enable the log debugging/log/trap on
the terminal monitor. Use the
undo terminal monitor command to disable these
functions.
By default, enable these functions for the console user and disable them for the
terminal user.
This command only takes effect on the current terminal where the commands are
input. The debugging/log/trap information can be output to the current terminal,
beginning in user view. When the terminal monitor is shut down, no
debugging/log/trap information will be displayed in local terminal, which is equals
to having performed the
undo terminal debugging, undo terminal logging,
undo terminal trapping commands. When the terminal monitor is enabled to use
terminal debugging / undo terminal debugging, terminal logging /
terminal logging and terminal trapping / undo terminal trapping
respectively to enable or disable the corresponding functions.
Example
Disable the terminal monitor.
<SW5500>undo terminal monitor
terminal trapping Syntax
terminal trapping
undo terminal trapping
View
User view
Parameter
None
To Next Page
Loading...
