34 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
Example
To change the command line interface from English to Chinese, enter the
following:
<SW5500-ui-aux0>language-mode chinese
lock Syntax
lock
View
User View
Parameter
None
Description
Use the lock command to lock the current user interface and prevent
unauthorized users from accessing it. An authorized user must enter a valid
password to access the interface.
Example
To lock the current user interface, enter the following:
<SW5500>lock
Password: xxxx
Again: xxxx
parity Syntax
parity { even | mark | none | odd | space }
undo parity
View
User Interface View
Parameter
even: Sets the Switch to even parity.
mark: Sets the Switch to mark parity (1)
none: Sets the Switch to perform no parity checking.
odd: Sets the Switch to odd parity.
space: Sets the Switch to zero parity (0)
Description
Use the parity command to configure the parity mode on the AUX (Console)
port. Use the
undo parity command to restore the default parity mode (no parity
checking).
This command can only be performed in the AUX user interface view.
To Next Page
Loading...
