3Com 5500G-EI - Dot1 X Dhcp-Launch; Dot1 X Max-User

346 CHAPTER 11: USING AAA AND RADIUS COMMANDS
not necessary to transfer the EAP packet to a standard RADIUS packet first and
then send it to RADIUS server.
To use PAP, CHAP or EAP authentication, RADIUS server should support PAP, CHAP
or EAP authentication respectively.
Related command: display dot1x.
Example
Configure 802.1x user to use PAP authentication
<SW5500>system-view
System View: return to User View with Ctrl-Z
[SW5500]dot1x authentication-method pap
dot1x dhcp-launch Syntax
dot1x dhcp-launch
undo dot1x dhcp-launch
View
System View
Parameter
None
Description
Use the dot1x dhcp-launch command to set 802.1x to prevent the Switch from
triggering user ID authentication for users who configure static IP addresses in a
DHCP environment. Use the
undo dot1x dhcp-launch command to allow the
Switch to trigger ID authentication.
By default, the Switch can trigger user ID authentication for users who configure
static IP addresses in a DHCP environment.
Related command: dot1x.
Example
Prevent the Switch from triggering the authentication ID for users who configure
static IP addresses in a DHCP environment.
<SW5500>system-view
System View: return to User View with Ctrl-Z
[SW5500]dot1x dhcp-launch
dot1x max-user Syntax
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
View
Ethernet Port View