3Com 5500G-EI - Display Snmp-Agent Group

SNMP Configuration Commands 475
Description
Use the display snmp-agent community command to display the currently
configured community names.
Example
Display the currently configured community names.
<SW5500>display snmp-agent community
community name:public
group name:public
storage-type: nonVolatile
community name:tom
group name:guest
storage-type: nonVolatile
display snmp-agent
group
Syntax
display snmp-agent group [ group-name ]
View
All views
Parameter
groupname: Group name, ranging from 1 to 32 bytes.
Description
Use the display snmp-agent group command to display group name, safe
mode, state of various views and storage modes.
Example
Display SNMP group name and safe mode.
<SW5500>display snmp-agent group
groupname: guest
Security model: v2c noAuthnoPriv
readview:v1default
writeview: no writeview specified
notifyview: *tv.FFFFFFFF
storage-type: volatile
The following table describes the output fields.
Table 58 Output description of the display snmp-agent group command
Field Description
groupname SNMP Group name of the user
Security model The security model adopted by SNMP
readview Read-only MIB view name corresponding to that group
writeview Writable MIB view corresponding to that group
notifyview The name of the notify MIB view corresponding to that group
storage-type Storage type