3Com 5500G-EI - Peer; Preference

RIP Configuration Commands 167
When the network command is used on an IP address, the interface on this
network segment is enabled. For example, if you view the
network 129.102.1.1
with both the
display current-configuration command and the display
rip
, the IP address is shown as 129.102.0.0.
Related commands: rip work.
Example
To enable RIP on the interface with the network address 129.102.0.1, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]rip
[SW5500-rip]network 129.102.0.0
peer Syntax
peer ip_address
undo peer ip_address
View
RIP view
Parameter
ip_address Enter the interface IP address of the peer router.
Description
Use the peer command to configure the destination address of the peer device.
Use the undo peer command to cancel the set destination address. By default,
there is no destination address.
3Com recommends that you do not use this command. RIP can use unicast to
exchange information with non-broadcasting networks. If required, you can use
this command to specify the destination address of the peer device.
Example
To specify the sending destination address as 202.38.165.1, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]rip
[SW5500-rip]peer 202.38.165.1
preference Syntax
preference value
undo preference
View
RIP view