3Com 5500G-EI - Multicast Common Configuration Commands; Debugging Multicast Forwarding; Debugging Multicast Kernel-Routing

242 CHAPTER 7: USING MULTICAST PROTOCOL COMMANDS
Related command: igmp-snooping.
Example
Clear IGMP Snooping statistics information.
<SW5500>reset igmp-snooping statistics
Multicast Common
Configuration
Commands
This section describes how to use the Multicast Common configuration commands
on your Switch 5500G-EI.
debugging multicast
forwarding
Syntax
debugging multicast forwarding
undo debugging multicast forwarding
View
User View
Parameter
None
Description
Use the debugging multicast forwarding to enable multicast packet
forwarding debugging functions.
Use the undo debugging multicast forwarding to disable the debugging
functions.
By default, the debugging function is disabled.
Example
Enable multicast packet forwarding debugging functions.
<SW5500>debugging multicast forwarding
debugging multicast
kernel-routing
Syntax
debugging multicast kernel-routing
undo debugging multicast kernel-routing
View
User View
Parameter
None
Description
Use the debugging multicast kernel-routing to enable multicast kernel
routing debugging functions.