104 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
IP Address
Configuration
Commands
This section describes the commands you can use to configure and manage IP
Addressing on your Switch 5500G-EI.
display ip host Syntax
display ip host
View
All Views
Parameter
None
Description
Use the display ip host command to display all host names and their
corresponding IP addresses.
Example
To display all host names and their corresponding IP addresses, type the following:
<SW5500>display ip host
The information displays in the following format:
Host Age Flags Address
My 0 static 1.1.1.1
Aa 0 static 2.2.2.4
display ip interface Syntax
display ip interface
interface-type interface-number
View
All views
Parameter
vlan_id
Enter the identifier of the vlan interface.
Description
Use the display ip interface vlan-interface command to view information
on the specified interface.
Example
To display information for VLAN-interface 1, enter the following:
<SW5500>display ip interface vlan-interface 1
The information displays in the following format:
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
To Next Page
Loading...
