OSPF Configuration Commands 193
display ospf lsdb Syntax
display ospf [
process-id
] [
area_id
] lsdb [ brief | [ asbr | ase |
network | nssa | router | summary ] [
ip_address
] [ originate-router
ip
_
address
| self-originate ]]
View
All Views
Parameters
process-id
Enter the process ID of OSPF, ranging from 1 to 65535. The command
is applied to all current OSPF processes if you do not specify a process ID.
area_id
Enter the ID of the OSPF area, as either an ID number or an IP address.
brief Enter to view brief information.
asbr Enter to view information about summary ASBR-LSA.
ase Enter to view information about AS-external-LSA.
network Enter to view information about the Network LSA.
nssa Enter to view information about the NSSA-external-LSA.
router Enter to view information about the Router-LSA.
summary Enter to view information about Summary-Net-LSA.
originate-router Enter to view information about the LSA generator.
self-originate Enter to view information about self-originated LSA.
Table 30 Output Description of the display ospf interface Command
Field Description
Cost Cost of the interface
State State of the interface state machine
Type Network type of OSPF
Priority Priority of DR for interface election
Designated Router Designated router on the network in which the interface resides
Backup Designated
Router
Backup designated router on the network in which the interface resides
Timers OSPF timers:
■ Hello — Interval of hello packets
■ Dead — Interval of dead neighbors
■ Poll — Interval of poll
■ Retransmit — Interval of retransmitting LSA
■ Transmit delay — Delay time of transmitting LSA
To Next Page
Loading...
