3Com 5500G-EI - Frequency; Test-Type

HWPing Commands 455
View
HWPing Test Group View
Parameter
ip-address: Destination IP address in a test
Description
Use the destination-ip command to configure the destination IP address in the
test.
Use the undo destination-ip command to delete the configured destination IP
address.
By default, no destination IP address is configured for any test.
Example
Set the destination IP address in the test to 169.254.10.3
[SW5500-administrator-icmp]destination-ip 169.254.10.3
frequency Syntax
frequency interval
undo frequency
View
HWPing Test Group View
Parameter
interval: Automatic test interval, in the range 0 to 65535. Default is 0 which
means no automatic test.
Description
Use the frequency command to configure an automatic test interval.
Use the undo frequency command to disable an automatic test.
The system automatically tests at intervals specified by this command, where the
argument
interval is greater than 0.
For the related command, see count.
Example
Set the automatic test interval to 10 seconds.
[SW5500-administrator-icmp]frequency 10
test-type Syntax
test-type type
View
HWPing Test Group View