Log Commands 469
info-center switch-on Syntax
info-center switch-on {
unit-id
| master | all } [ debugging |
logging | trapping ]*
undo info-center switch-on {
unit-id
|
master
| all } [ debugging |
logging | trapping ]*
View
System view
Parameter
unit-id:
Unit ID of switch.
master: Master switch of Fabric.
all: All switches of Fabric.
debugging: Debugging information.
logging: Log information.
trapping: Trap information.
Description
Use the info-center switch-on command to turn on the information
synchronization switch of the specified switch.
Use the undo info-center switch-on command to turn off the information
synchronization switch of the specified switch.
By default, the debugging information synchronization switch on master unit is
enabled, log information and trap information switches on master unit are
disabled, all information synchronization switches on slave unit are disabled.
After the forming of a Fabric by switches which support the XRN, the log,
debugging and trap information among the switches is synchronous. The
synchronization process is as follows: each switch sends its own information to
other switches in the Fabric and meantime receives the information from others,
and then the switch updates the local information to ensure the information
coincidence within the Fabric.
The switch provides command line to turn on/off the synchronization switch in
every switch. If the synchronization switch of a switch is turned off, it does not
send information to other switches but still receives information from others.
Example
To turn on the trapping information synchronization switch of the unit 2, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center switch-on 2 trapping
To Next Page
Loading...
