3Com 5500G-EI - Display Saved-Configuration; Display this

Configuration File Management Commands 413
To view the pre-positive and post-positive configuration information, enter the
following:
<SW5500>display current-configuration configuration
display
saved-configuration
Syntax
display saved-configuration [ unit unit-id ]
View
All views
Parameter
unit unit-id : Specify the Unit ID of switch.
Description
Use the display saved-configuration command to view the configuration files
in the flash memory of the Switch.
If the Switch works abnormally after power on, execute the display
saved-configuration
command to view the startup configuration of the Switch.
Related commands: save, reset saved-configuration, display
current-configuration
.
Example
To display configuration files in flash memory of the Switch, enter the following:
<SW5500>display saved-configuration
display this Syntax
display this
View
All views
Parameter
None
Description
Use the display this command, to display the configuration of the current view.
If you need to authenticate whether the configurations are correct, after you have
finished a set of configurations under a view to use the
display this command
to view the parameters.
Some effective parameters are not displayed if they are the same as the default
ones. Some ineffective parameters that were configured by the user, are not
displayed either.
Associated configuration of the interface is displayed when executing the
command in different interface views, related configuration of the protocol view is
displayed when excecuting this command in different protocol views, and all the