3Com 5500G-EI - Port Trunk Pvid Vlan; Reset Counters Interface

Ethernet Port Configuration Commands 65
Example
To add the trunk port Ethernet1/0/1 to VLAN 2, VLAN 4 and all VLANs in the range
50-100, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]port trunk permit vlan 2 4 50 to 100
port trunk pvid vlan Syntax
port trunk pvid vlan vlan_id
undo port trunk pvid
View
Ethernet Port View
Parameter
vlan_id: Enter a VLAN ID in the range 2 to 4094, as defined in IEEE802.1Q. This
is the VLAN that you want to be the default VLAN for a trunk port.
The default is 1.
Description
Use the port trunk pvid vlan command to configure the default VLAN ID for a
trunk port. Use the
undo port trunk pvid command to restore the default VLAN
ID for a trunk port.
The default VLAN ID of local trunk port should be consistent with that of the peer
one, otherwise packets cannot be properly transmitted.
Related command: port link-type.
Example
To configure the trunk port Ethernet1/0/1 to the default VLAN of 100, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]port trunk pvid vlan 100
reset counters interface Syntax
reset counters interface [ interface_type | interface_type
interface_num | interface_name ]
View
User view