36 CHAPTER 1: USING SYSTEM ACCESS COMMANDS
■ system view
■ menu views, for example VLAN view, Ethernet port view, and so on.
Related commands: return, system-view.
Example
To return to user view from system view, enter the following:
[SW5500]quit
<SW5500>
return Syntax
return
View
System view or higher
Parameter
None
Description
Use the return command to return to user view from any other view.
Ctrl+Z performs the same function as the return command.
To return to the next highest level of view, use quit.
Example
To return to user view from any other view (the example below shows the
command entered from the system view), enter the following.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]return
<SW5500>
screen-length Syntax
screen-length
screen-length
undo screen-length
View
User interface view
Parameter
screen-length:
Enter the maximum number of information lines that you want
to display on a terminal screen, ranging from 0 to 512. The default is 24.
Description
Use the command screen-length to configure how many information lines
(maximum) will be displayed on the screen of a terminal. Use the command
undo
screen-length to restore the default of 24 lines.
To Next Page
Loading...
