3Com 5500G-EI - Reboot; Schedule Reboot at

440 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
Related command: reboot, schedule reboot at, schedule reboot delay,
undo schedule reboot.
Example
Display the configuration of the schedule reboot terminal service parameters of
the current switch.
<SW5500>display schedule reboot
Reboot system at 16:00:00 2002/11/1 (in 2 hours and 5 minutes).
reboot Syntax
reboot [ unit unit-id ]
View
User view
Parameter
unit unit-id : Specify the Unit ID of the switch
Description
Use the reboot command to reset the Switch when failure occurs.
Example
Reboots the Switch.
<SW5500>reboot
This will reboot device. Continue? [Y/N]
schedule reboot at Syntax
schedule reboot at hh:mm [ yyyy/mm/dd ]
undo schedule reboot
View
User view
Parameter
hh:mm : Reboot time of the switch, in the format of "hour: minute" The hh ranges
from 0 to 23, and the mm ranges from 0 to 59.
yyyy/mm/dd : Reboot date of the switch, in the format of "year/month/day. The
yyyy ranges from 2000 to 2099, the mm ranges from 1 to 12, and the value of dd
is related to the specific month.
Description
Use the schedule reboot at command to enable the timing reboot function of
the switch and set the specific reboot time and date.
Use the undo schedule reboot command to disable the timing reboot function.
By default, the timing reboot switch function is disabled.