3Com 5500G-EI - interface VLAN-interface

82 CHAPTER 3: USING VLAN COMMANDS
the command display vlan all to display information on all the VLANs. Use
the command
display vlan dynamic to display information on VLANs created
dynamically by the system. Use the command
display vlan static to display
information of VLAN created statically by the system.
Related command: vlan.
Examples
To display information about VLAN 1:
<SW5500>display vlan 1
VLAN ID: 1
VLAN Type: static
Route Interface: configured
IP Address: 161.71.61.206
Subnet Mask: 255.255.255.0
Description: VLAN 0001
Tagged Ports:
GigabitEthernet1/0/1 GigabitEthernet1/0/2 GigabitEthernet 1/0/3
Untagged Ports:
Ethernet1/0/1 Ethernet1/0/2 Ethernet1/0/3
interface VLAN-interface Syntax
interface vlan-interface vlan_id
undo interface vlan-interface vlan_id
View
System View
Parameter
vlan_id: Enter the ID of the VLAN interface you want to configure, in the range
1 to 4094. Note that VLAN1 is the default VLAN and cannot be deleted.
Description
Use the interface vlan-interface command to enter a VLAN interface view
and use the related configuration commands. Use the
undo interface
vlan-interface
command to exit the current VLAN interface.
Related command: display interface vlan-interface.
Example
To enter the interface view of VLAN1, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface vlan-interface 1
port Syntax
port interface_list