3Com 5500G-EI - Display Mac-Address Aging-Time

432 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
For details about the interface-type , interface-num and interface-name
parameters, refer to the Port Configuration in this manual.
count: the display information will only contain the number of MAC addresses in
the MAC address table if the user enters this parameter when using this
command.
Description
Use the display mac-address command to display MAC address table
information.
When managing the Layer-2 addresses of the switch, the administrator can
perform this command to view such information as the Layer-2 address table,
address status (static or dynamic), Ethernet port of the MAC address, VLAN of the
address, and system address aging time.
For the related commands, see mac-address, mac-address timer.
Example
Show the information of the entry with MAC address at 00e0-fc01-0101
[SW5500]display mac-address 00e0-fc01-0101
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
00e0-fc01-0101 1 Learned GigabitEthernet1/0/1 300
display mac-address
aging-time
Syntax
display mac-address aging-time
View
All views
Parameter
None
Description
Use the display mac-address aging-time command to display the aging time
of the dynamic entry in the MAC address table.
For the related commands, see mac-address, mac-address timer, display
mac-address
.
Examples
Display the aging time of the dynamic entry in the MAC address table.
[SW5500]display mac-address aging-time
mac-address aging-time: 300s
The above information indicates that the aging time of the dynamic entry in the
MAC address is 300s.
[sw5500] display mac-address aging-time
mac-address aging-time: no-aging