3Com 5500G-EI - Display Dhcp-Security; Display Dhcp-Server

122 CHAPTER 5: USING NETWORK PROTOCOL COMMANDS
To delete the IP addresses of DHCP Server group1, enter the following:
[SW5500]undo dhcp-server 1
display dhcp-security Syntax
display dhcp-security [ ip_address | dynamic | static ] [ unit
unit-id ]
.
View
All views
Parameters
ip_address Enter to display user address entries of the specific IP address..
dynamic Enter to display the dynamic address table entry.
static Enter to display the static address table entry.
unit unit-id Enter to display user address entries of the specific unit ID, ranging
from 1 to 8.
Description
Use the display dhcp-security command to display information on all clients.
Use the display dhcp-security ip_address command to display information
on a specific client. Use the IP address to identify the client.
Example
To display the IP addresses for each client, enter the following:
<SW5500>display dhcp-security
The information displays in the following format:
Unit ID IP Address MAC Address Type
1 2.2.2.2 0005.5d02.f2b2 Static
1 3.3.3.3 0005.5d02.f2b3 Dynamic
--- 2 dhcp-security item(s) found ---
display dhcp-server Syntax
display dhcp-server groupNo
View
All views.
Parameter
groupNo Enter a DHCP Server group number, in the range 0 to 19.