Log Commands 467
[SW5500]info-center snmp channel 6
info-center source Syntax
info-center source {
modu-name
| default } channel {
channel-number
|
channel-name
} [ debug { level
severity
| state
state
}* | log {
level
severity
| state
state
}* | trap { level
severity
| state
state
} ] *
undo info-center source {
modu-name
| default } channel {
channel-number | channel-name
}
View
System view
Parameter
modu-name:
Module name.
default: All the modules.
log: Log information.
trap: Trap information.
debugging: Debugging information.
level: Level.
severity:
Information level, do not output information below this level. By
default, the log information level is warnings, the trap information level is
debugging, the debugging information level is debugging.
Information at different levels is as follows:
emergencies: Level 1 information, which cannot be used by the system.
alerts: Level 2 information, to be reacted immediately.
critical: Level 3 information, critical information.
errors: Level 4 information, error information.
warnings: level 5 information, warning information.
notifications: Level 6 information, showed normally and important.
informational: Level 7 information, notice to be recorded.
debugging: Level 8 information, generated during the debugging progress.
If you only specify the level for one or two of the three types of information, the
level(s) of the unspecified type(s) return to the default. For example, if you only
define the level of the log information, then the levels of the trap and debugging
information return to the defaults.
channel-number:
Channel number to be set.
To Next Page
Loading...
