3Com 5500G-EI - Display Ospf Vlink

200 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
display ospf vlink Syntax
display ospf [ process-id ] vlink
View
All Views
Parameter
process-id : Enter the process ID of OSPF, ranging from 1 to 65535. The
command is applied to all current OSPF processes if you do not specify a process
ID.
Description
Use the display ospf vlink command to view the information about OSPF
virtual links.
Example
To view OSPF virtual links information, enter the following:
<SW5500>display ospf vlink
OSPF Process 1 with Router ID 1.1.1.1
The information displays in the following format:
Virtual links
Virtual-link Neighbor-id -> 2.2.2.2, State: Full
Cost: 0 State: Full Type: Virtual
Transit Area: 0.0.0.2
Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1
Tab le 37 Output Description of the display ospf routing Command
Field Description
Destination Destination of network segment
Cost Cost of route
Type Type of route
NextHop Next hop of route
AdvRouter Router ID of the router advertising the route
Area Area ID
Intra Area Number of intra-area routes
Inter Area Number of inter-area routes
ASE Number of external routes
NSSA Number of NSSA routes
Tab le 38 Output Description of the display ospf vlink Command
Field Description
Virtual-link
Neighbor-id
Router ID of virtual-link neighbor router
State State
Interface IP address of the interface on the virtual link