Access Management Configuration Commands 127
display isolate port Syntax
display isolate port
View
Any view
Parameter
none
Description
Use the display isolate port command to view port isolation information.
Example
To display port isolation information, enter the following:
<SW5500>display isolate port
UNIT 1:
Ethernet1/0/1
port isolate Syntax
port isolate
undo port isolate
View
Ethernet Port View
Parameter
None
Description
Use the port isolate command to add a port to an isolation group using the
following commands, and achieves port-to-port isolation between this port and
other ports of this group, that is, Layer 2 forwarding between the isolated ports is
not available.
Use the undo port isolate command to remove a port from an isolation group.
By default, a port is not in an isolation group, namely Layer 2 forwarding is
achievable between this port and other ports.
Table 11 Output Description of the display am Command
Field Description
Status AM state on the port: enabled or disabled
IP Pools IP pools. NULL represents no configuration. Each IP address section is
represented in X.X.X.X (number), of these, "X.X.X.X" represents the
first address, and "number" represents that "number" consecutive IP
addresses from the beginning of this address are within the IP pools
To Next Page
Loading...
