3Com 5500G-EI - IGMP Configuration Commands; Debugging Igmp; Display Igmp Group

250 CHAPTER 7: USING MULTICAST PROTOCOL COMMANDS
Example
Clear the route entry with address of 225.5.4.3 from the core multicast routing
table.
<SW5500>reset multicast routing-table 225.5.4.3
Clear statistic information of the forward entry with address of 225.5.4.3 from the
MFC forwarding table.
<SW5500>reset multicast forwarding-table statistics 225.5.4.3
IGMP Configuration
Commands
This section describes how to use the IGMP Configuration commands on your
Switch 5500G-EI.
debugging igmp Syntax
debugging igmp { all | event | host | packet | timer }
undo debugging igmp { all | event | host | packet | timer }
View
User View
Parameter
all: Enables all the debugging information for IGMP functions.
event: Enables debugging information for IGMP events.
host: Enables debugging information for IGMP hosts
packet: Enables debugging information for IGMP packets.
timer: Enables debugging information for IGMP timers.
Description
Use the debugging igmp command to enable IGMP debugging functions.
Use the undo debugging igmp command to disable the debugging functions.
By default, IGMP debugging functions are disabled.
Example
Enable all IGMP debugging functions
<SW5500>debugging igmp all
display igmp group Syntax
display igmp group [ group-address | interface interface-type
interface-number
]
View
Any View