VLAN Configuration Commands 81
■ VLAN interface description
■ Maximum Transmit Unit (MTU)
■ IP address and subnet mask
■ Format of the IP frames
■ MAC hardware address.
Use display interface vlan-interface to display information on all VLAN
interfaces. Use
display interface vlan-interface
vlan_id
to display
information on a specific VLAN interface
Related command: interface Vlan-interface.
Example
To display information on VLAN interface 1, enter the following:
<SW5500>display interface vlan-interface 1
The information displays in the following format:
Vlan-interface1 current state :DOWN
Line protocol current state :DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc07-4101
Internet Address is 161.71.61.206/24 Primary
Description : Vlan-interface1 Interface
The Maximum Transmit Unit is 1500
display vlan Syntax
display vlan [
vlan_id
| all | static | dynamic ]
View
All views
Parameter
vlan_id:
Enter to display information on a specified VLAN.
all: Enter to display information on all VLANs.
static: Enter to display information on VLANs created statically by the system.
dynamic: Enter to display information on VLANs created dynamically by the
system.
Description
Use the display vlan command to view related information about specific
VLANs, specific types of VLAN or all VLANs. The information includes: VLAN type,
whether the Route interface has been configured on the VLAN, the Broadcast
Suppression max-ratio, the VLAN description, and a list of the tagged and
untagged ports that belong to the VLAN. Use the command
display vlan to
display a summary of the VLAN IDs of all VLANs configured on the system. Use the
command
display vlan
vlan_id
to display information on a specific VLAN. Use
To Next Page
Loading...
