3Com 5500G-EI - Display Ip Ip-Prefix; Display Route-Policy

222 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]route-policy permit node 1
% New sequence of this list
[SW5500-route-policy]apply tag 100
display ip ip-prefix Syntax
display ip ip-prefix [ ip_prefix_name ]
View
All Views
Parameter
ip_prefix_name Enter displayed address prefix list name.
Description
Use the display ip ip-prefix command to view the address prefix list.
Related command: ip ip-prefix.
Example
Display the information of the address prefix list named to p1.
<SW5500>display ip ip-prefix p1
name index conditions ip-prefix / mask GE LE
p1 10 permit 10.1.0.0/16 17 18
display route-policy Syntax
display route-policy [ route _ policy _ name ]
View
All Views
Parameter
route_policy_name Specify displayed Route-policy name.
Description
Use the display route-policy command to view the configured Route-policy
Related command: route-policy.
Tab le 39 Output Description of the display ip-ip prefix Command
Field Description
name Name of ip-prefix
index Internal sequence number of ip-prefix
conditions Mode: permit or deny
ip-prefix Address and network segment length of ip-prefix
GE Greater-equal value of ip-prefix network segment length
LE Less-equal value of ip-prefix network segment length