3Com 5500G-EI - Memory Auto-Establish Enable; Memory { Safety | Limit

Route Capacity Configuration Commands 233
memory of the Ethernet switch reduces to a lower limit, the connection will be
disconnected forcibly).
Related commands: memory auto-establish enable, memory { safety |
limit }
, display memory limit.
Example
Disable memory resume of the current Ethernet switch and recover connections of
all the protocols automatically.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]memory auto-establish disable
memory auto-establish
enable
Syntax
memory auto-establish enable
View
System View
Parameter
None
Description
Use the memory auto-establish enable command to allow the routing protocol
connection that is forcibly disconnected to recover automatically when the idle
memory of the Switch reaches this value.
By default, when the idle memory of the Switch recovers to a safety value,
connections of all the routing protocols will always recover (when the idle memory
of the Ethernet switch reduces to a lower limit, the connection will be
disconnected forcibly).
Related commands: memory auto-establish disable, memory { safety |
limit }
, display memory limit.
Example
Enable memory resume of the current Switch and recover connections of all the
protocols automatically.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]memory auto-establish enable
memory { safety | limit } Syntax
memory { safety safety_value | limit limit_value }*
undo memory [ safety | limit ]
View
System View