3Com 5500G-EI - Display Radius Statistics

RADIUS Protocol Configuration Commands 377
SchemeName = default system Index=0 Type=3Com
Primary Auth IP =127.0.0.1 Port=1645
Primary Acct IP =127.0.0.1 Port=1646
Second Auth IP =0.0.0.0 Port=1812
Second Acct IP =0.0.0.0 Port=1813
Auth Server Encryption Key= 3Com
Acct Server Encryption Key= 3Com
Accounting method = required
TimeOutValue(in second)=3 RetryTimes=3 RealtimeACCT(in minute)=12
Permitted send realtime PKT failed counts =5
Retry sending times of noresponse acct-stop-PKT =500
Quiet-interval(min) =5
Username format =without-domain
Data flow unit =Byte
Packet unit =1
unit 1 :
Primary Auth State=active, Second Auth State=block
Primary Acc State=active, Second Acc State=block
------------------------------------------------------------------
Total 1 RADIUS scheme(s). 1 listed
display radius statistics Syntax
display radius statistics
View
All views
Parameter
None
Description
Use the display radius statistics command to view the statistics information
of RADIUS packet.
This command outputs the statistics information about the RADIUS packets. The
displayed packet information can help with RADIUS diagnosis and
troubleshooting.
Related command: radius scheme.
Example
To display the statistics information of RADIUS packets, enter the following:
<SW5500>display radius statistics
state statistic(total=0):
DEAD=1048 AuthProc=0 AuthSucc=0
AcctStart=0 RLTSend=0 RLTWait=0
AcctStop=0 OnLine=0 Stop=0
StateErr=0
Receive and Send packets statistic:
Send PKT total :0 Receive PKT total:0
RADIUS received packets statistic:
Code= 2,Num=0 ,Err=0
Code= 3,Num=0 ,Err=0