Ethernet Port Link Aggregation Commands 77
port link-aggregation
group
Syntax
port link-aggregation group
agg_id
undo port link-aggregation group
View
Ethernet Port View
Parameter
agg_id:
Aggregation group ID, in the range of 1 to 464.
Description
Use the port link-aggregation group
agg_id
command to add an Ethernet
port into a manual or static aggregation group. Use the
undo port
link-aggregation group
command, to delete an Ethernet port from a manual or
static aggregation group.
Related command: display link-aggregation verbose.
Example
To add Ethernet1/0/1 into aggregation group 22, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]port link-aggregation group 22
reset lacp statistics Syntax
reset lacp statistics [ interface {
interface_type interface_number
|
interface_name
} [ to {
interface_type interface_num
|
interface_name
} ] ]
View
User View
Parameter
interface {
interface_type interface_ num
|
interface_name
} [ to {
interface_type interface_ num
|
interface_name
} ]: Specifies ports. You
can specify multiple sequential ports with the to parameter, instead of specifying
only one port.
interface_name:
Specifies port name, in the format of
interface_name =
interface_type interface_num.
interface_type:
Specifies port type and
interface_num
port number.
For more information, see the parameter item for the interface command.
To Next Page
Loading...
