AAA Configuration Commands 371
You can use either the scheme or radius-scheme command to specify the RADIUS
scheme for an ISP domain. If both of these two commands are used, the latest
configuration will take effect.
Related command: radius scheme.
Example
To specify the current ISP domain, 3Com163.net, to use the RADIUS scheme
3Com, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]domain marlboro.net
[SW5500-isp-marlboro.net]scheme radius-scheme 3Com
self-service-url Syntax
self-service-url enable
url-string
self-service-url disable
View
ISP Domain View
Parameter
url-string
: The URL address of the page used to change the user password on
the self-service server, a string with 1 to 64 characters. This string cannot contain
"?" character. If "?" is contained in the URL address, you must replace it with "|"
when inputting the URL address in the command line.
Description
Use the self-service-url enable command to configure self-service server
URL.
Use the self-service-url disable command to remove the configuration.
By default, self-service server URL is not configured on the Switch.
This command must be incorporated with a RADIUS server (such as a CAMS
server) that supports self-service. Self-service means that users can manage their
accounts and card numbers by themselves. And a server with the self-service
software is called a self-service server.
Once this function is enabled on the Switch, users can locate the self-service server
and perform self-management through the following operations:
■ Select "Change user password" on the 802.1x client.
■ After the client opens the default explorer (IE or NetScape), locate the specified
URL page used to change the user password on the self-service server.
■ Change user password on this page.
The "Change user password" option is available only after the user passed the
authentication; otherwise, this option is in grey and unavailable.
To Next Page
Loading...
