RADIUS Protocol Configuration Commands 395
[SW5500]radius scheme 3Com
[SW5500-radius-3Com]timer response-timeout 5
user-name-format Syntax
user-name-format { with-domain | without-domain }
View
RADIUS Scheme View
Parameter
with-domain: Specifies to send the username with domain name to RADIUS
server.
without-domain: Specifies to send the username without domain name to
RADIUS server.
Description
Use the user-name-format command to configure the username format sent to
RADIUS server.
By default, the username sent to RADIUS servers includes the ISP domain name.
The supplicants are generally named in userid@isp-name format. The part
following “@” is the ISP domain name. The Switch will put the users into certain
ISP domains according to the domain names. However, some earlier RADIUS
servers reject the username including the ISP domain name. In this case, the
username will be sent to the RADIUS server after its domain name is removed.
Accordingly, the Switch provides this command to decide whether the username
that is to be sent to RADIUS server carries the ISP domain name or not.
If a RADIUS scheme is configured to reject usernames including ISP domain names,
the RADIUS scheme shall not be simultaneously used in more than one ISP
domains. Otherwise, the RADIUS server will regard two users in different ISP
domains as the same user by mistake, if they have the same username (excluding
their respective domain names.)
Related command: radius scheme.
Example
To specify to send the username without domain name to RADIUS server, enter
the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]radius scheme 3Com
[SW5500-radius-3Com]user-name-format without-domain
To Next Page
Loading...
