296 CHAPTER 8: USING QOS/ACL COMMANDS
line-rate Syntax
line-rate outbound
target-rate
undo line-rate outbound
View
Ethernet Port View
Parameter
target-rate
: The total limited rate of packets sent by interfaces. Unit in Kbps.
The number inputted must be a multiple of 64. For 1000 Mbps port, the range is
from 64 to 1000000.
Description
Use the line-rate command, to limit the total rate of the packets delivered by
interfaces. Use the
undo line-rate command, to cancel the configuration of limit
rate at interfaces.
The granularity of line rate is 64 kbps.
Example
Set the rate limitation of interface GigabitEthernet1/0/1 to 128 kbps.
<SW5500>system-view
System View: return to User View with Ctrl+Z
[SW5500]interface gigabitethernet 1/0/1
[SW5500-GigabitEthernet1/0/1]line-rate outbound 128
[SW5500]interface gigabitethernet 1/0/1
mirrored-to Syntax
mirrored-to inbound { ip-group
acl-number
[ rule
rule
[ link-group
acl-number
rule
rule
] ] | link-group
acl-number
[ rule
rule
] } { cpu
| monitor-interface }
undo mirrored-to inbound { ip-group
acl-number
[ rule
rule
[
link-group
acl-number
rule
rule
] ] | link-group
acl-number
[ rule
rule
] }
View
Ethernet Port View
Parameter
inbound: Performs traffic mirror for the packets received by the interface.
ip-group
acl-number
: Activates IP ACLs, including basic and advanced ACLs.
acl-number
: Sequence number of ACL, ranging from 2000 to 3999.
link-group
acl-number
: Activates Layer 2 ACLs.
acl-number
: Sequence number
of ACL, ranging from 4000 to 4999.
rule
rule
: Specifies the subitem of an active ACL, ranging from 0 to 65534; if
not specified, all subitems of the ACL will be activated. If only IP ACL or Layer 2
ACL are activated, this parameter can be omitted. If both IP and Layer 2 ACL are
activated at the same time, the
rule
parameter cannot be omitted.
To Next Page
Loading...
