Multicast Common Configuration Commands 247
Output packet count on outgoing interface: 0
Total number of packets for this source-group pair: 0
Protocol: PIM
Forwarding TTL: 0
Forwarding Code: No error
multicast route-limit Syntax
multicast route-limit
limit
undo multicast route-limit
View
System View
Parameter
limit: Limits the capacity of the multicast routing table, in the range of 0 to 256.
Description
Use the multicast route-limit command to limit the capacity of multicast
routing table. When the preset capacity is exceeded, the router will discard new (S,
G) protocol and data packets.
Use the undo multicast route-limit command to restore the limit to the
default value.
By default, the capacity of multicast routing table is set to 256.
If the existing route entries exceed the capacity value you configured using this
command, the system will not delete the existing entries, but prompts the user
with the following message:
Existing route entries exceed the configured
capacity value
.
The new configuration overwrites the old one if you run the command for a
second time.
Example
Limit multicast routing table capacity at 256.
[SW5500]multicast route-limit 256
multicast routing-enable Syntax
multicast routing-enable
undo multicast routing-enable
View
System View
Parameter
None
Description
Use the multicast routing-enable to enable IP multicast routing.
To Next Page
Loading...
