Voice VLAN Configuration Commands 89
By default, the Voice VLAN is in auto mode.
If required, the voice vlan mode auto and undo voice vlan mode auto
commands must be executed before the Voice VLAN features are enabled globally.
For the related command, see display voice vlan status.
Example
To set the Voice VLAN in manual mode, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]undo voice vlan mode auto
voice vlan security Syntax
voice vlan security enable
undo voice vlan security enable
View
System View
Parameter
None
Description
Use the voice vlan security enable command to enable the Voice VLAN
security mode. In this mode, the system can filter out the traffic whose source
MAC is not OUI when the traffic travels through the access port of IP Phone within
the Voice VLAN, while the other VLANs are not influenced. Use the
undo voice
vlan security enable
command to disable the Voice VLAN security mode.
By default, the Voice VLAN security mode is enabled.
For the related command, see display voice vlan status.
Example
To disable the Voice VLAN security mode, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]undo voice vlan security enable
To Next Page
Loading...
