EasyManua.ls Logo

3Com 5500G-EI - Primary Authentication

3Com 5500G-EI
530 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
382 CHAPTER 11: USING AAA AND RADIUS COMMANDS
Parameter
ip-address
: IP address, in dotted decimal format.
port-number
: Specifies UDP port number. ranging from 1 to 65535. .
Description
Use the primary accounting command to configure the IP address and port
number for the primary accounting server. Use the
undo primary accounting
command to restore the default IP address and port number of the primary
RADIUS accounting server.
By default, as for the newly created RADIUS scheme, the IP address of the primary
accounting server is 0.0.0.0, and the UDP port number of this server is 1813; as
for the "default system" RADIUS scheme created by the system, the IP address of
the primary accounting server is 127.0.0.1, and the UDP port number is 1646.
After creating a RADIUS scheme, you are supposed to set IP addresses and UDP
port numbers for the RADIUS servers, including primary/second
authentication/authorization servers and accounting servers. In real networking
environments, the above parameters shall be set according to the specific
requirements. However, you must set at least one authentication/authorization
server and an accounting server. Besides, ensure that the RADIUS service port
settings on the Switch is consistent with the port settings on the RADIUS server.
Related commands: key, radius scheme, state.
Example
To set the IP address of the primary accounting server of RADIUS scheme,
“3Com”, to 10.110.1.2 and the UDP port 1813 to provide RADIUS accounting
service, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]radius scheme 3Com
[SW5500-radius-3Com]primary accounting 10.110.1.2 1813
primary authentication Syntax
primary authentication
ip-address
[
port-number
]
undo primary authentication
View
RADIUS Server Group View
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP addresses of
the primary authentication/authorization is at 0.0.0.0.
port-number: Specifies UDP port number. ranging from 1 to 65535. By default,
the UDP port for authentication/authorization service is 1812 .

Table of Contents

Related product manuals