3Com 5500G-EI - Display Pim Rp-Info

PIM Configuration Commands 271
Example
View the contents of the PIM multicast routing table on the router.
<SW5500>display pim routing-table
PIMSM Routing Table
Total 0 (*,*,RP), 0 (*,G), 2 (S,G)
(192.168.1.2, 224.2.178.130),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
(192.168.1.2, 224.2.181.90),
Protocol 0x20: PIMSM, Flag 0x4: SPT
UpTime: 23:59, Timeout after 196 seconds
Upstream interface: VLAN-interface2, RPF neighbor: NULL
Downstream interface list: NULL
Total 2 entries listed
Table 49 Output description about PIM routing table
display pim rp-info Syntax
display pim rp-info [ group-address ]
View
All Views
Parameter
group-address: Specify the group address to be showed. If no multicast group is
specified, the RP information about all multicast groups will be displayed.
Description
Use the display pim rp-info to view the RP information of multicast group.
In addition, this command can also show the BSR and static RP information.
Example
<SW5500>display pim rp-info
PIM-SM RP-SET information:
BSR is: 192.168.1.1
Group/MaskLen: 224.0.0.0/4
RP 192.168.1.1, Version 2
priority: 0
uptime(from last update): 29:11, to expire in: 2:02
Field Description
RP Rendezvous Point
(S,G) Source address, multicast group
PIM-SM PIM Sparse Mode
SPT Shortest Path Tree
RPF Reverse Path Forwarding