354 CHAPTER 11: USING AAA AND RADIUS COMMANDS
View
User View
Parameter
interface
interface-list
: Ethernet port list including several Ethernet ports.
interface-list
= {
interface-num
[ to
interface-num
] } & < 1-10 >.
interface-num
specifies a single Ethernet port in the format
port-num
= {
interface-type interface-num
|
interface-name
}, where
interface-type
specifies the port type,
interface-num
specifies the port number and
interface-name
specifies the port name. For the respective meanings and value
ranges, read the Parameter of the Port Configuration section.
Description
Use the reset dot1x statistics command to reset the statistics of 802.1x.
This command can be used to re-perform statistics if the user wants to delete the
former statistics of 802.1x.
When the original statistics are cleared, if no port type or port number is specified,
the global 802.1x statistics of the Switch and 802.1x statistics on all the ports will
be cleared. If the port type and port number are specified, the 802.1x statistics on
the specified port will be cleared.
Related commands: display dot1x.
Example
Clear the 802.1x statistics on GigabitEthernet 1/0/1.
<SW5500>reset dot1x statistics interface Gigabitethernet 1/0/1
Centralized MAC
Address
Authentication
Configuration
Commands
debugging
mac-authentication
event
Syntax
debugging mac-authentication event
undo debugging mac-authentication event
View
User View
Parameter
None
To Next Page
Loading...
