RIP Configuration Commands 171
Parameter
None
Description
Use the rip input command to allow an interface to receive RIP packets. By
default, all interfaces except loopback interfaces are able to receive RIP packets.
Use the undo rip input command to block an interface from receiving RIP
packets.
This command is used in conjunction with two other two commands: rip output
and
rip work. The rip input and rip output commands control, respectively,
the receipt and the transmission of RIP packets on an interface. The
rip work
command allows both receipt and tranmission of RIP packets.
Related commands: rip output, rip work.
Example
To set the interface Vlan-interface 1 not to receive RIP packets, enter the
following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]interface Vlan-interface 1
[SW5500-Vlan-interface1]undo rip input
rip metricin Syntax
rip metricin
value
undo rip metricin
View
Interface View
Parameter
value
Enter an additional route metric to be added when receiving a packet,
ranging from 0 to 16. By default, the value is 0.
Description
Use the rip metricin command to configure an additional route metric to be
added to the route when an interface receives RIP packets.
Use the undo rip metricin command to restore the default value of this
additional route metric.
Related command: rip metricout.
Example
To set the additional route metric to 2 when the interface Vlan-interface 1 receives
RIP packets, enter the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
To Next Page
Loading...
