376 CHAPTER 11: USING AAA AND RADIUS COMMANDS
Parameter
None
Description
Use the display local-server statistics command to view the statistics of
local RADIUS authentication server.
Related command: local-server.
Example
To display the statistics of local RADIUS authentication server, enter the following
<SW5500>display local-server statistics
On Unit 1:
The localserver packet statistics:
Receive: 30 Send: 30
Discard: 0 Receive Packet Error: 0
Auth Receive: 10 Auth Send: 10
Acct Receive: 20 Acct Send: 20
On Unit 2:
The localserver packet statistics:
Receive: 0 Send: 0
Discard: 0 Receive Packet Error: 0
Auth Receive: 0 Auth Send: 0
Acct Receive: 0 Acct Send: 0
display radius Syntax
display radius [
radius-scheme-name
]
View
All views
Parameter
radius-scheme-name
: Specifies the RADIUS scheme name with a character string
not exceeding 32 characters. Display all RADIUS schemes when the parameter is
not set.
Description
Use the display radius command to view the configuration information of all
RADIUS schemes or a specified one.
By default, this command outputs the configuration information about the
specified or all the RADIUS schemes. The output can help with RADIUS diagnosis
and troubleshooting.
Related command: radius scheme.
Example
To display the configuration information of all the RADIUS schemes, enter the
following.
<SW5500>display radius
------------------------------------------------------------------
To Next Page
Loading...
