3Com 5500G-EI - Debugging Link-Aggregation Event; Debugging Lacp Packet

Ethernet Port Link Aggregation Commands 69
Description
Use the debugging link-aggregation error command to enable link
aggregation error debugging. Use the
undo debugging link-aggregation
error
command to disable link aggregation error debugging.
Example
To enable link aggregation error debugging, enter the following:
<SW5500>debugging link-aggregation error
debugging
link-aggregation event
Syntax
debugging link-aggregation event
undo debugging link-aggregation event
View
User View
Parameter
None
Description
Use the debugging link-aggregation event command to enable link
aggregation events debugging. Use the
undo debugging link-aggregation
event
command to disable link aggregation events debugging.
Example
To enable link aggregation events debugging, enter the following:
<SW5500>debugging link-aggregation event
debugging lacp packet Syntax
debugging lacp packet [ interface { interface_type interface_number
| interface_name } [ to { interface_type interface_num |
interface_name } ] ]
undo debugging lacp packet [ interface { interface_type
interface_number | interface_name } [ to { interface_type
interface_num
| interface_name } ] ]
View
User View
Parameter
interface { interface_type interface_ num | interface_name } [ to {
interface_type interface_ num | interface_name } ]: Specifies ports. You
can specify multiple sequential ports with the to parameter, instead of specifying
only one port.
interface_name: Specifies port name, in the format of interface_name =
interface_type interface_num.