RADIUS Protocol Configuration Commands 389
Parameter
ip-address
: IP address, in dotted decimal format. By default, the IP addresses of
second accounting server is at 0.0.0.0.
port-number
: Specifies the UDP port number, ranging from 1 to 65535. By
default, the accounting service is provided via UDP 1813.
Description
Use the secondary accounting command to configure the IP address and port
number for the second RADIUS accounting server. Use the
undo secondary
accounting
command to restore the IP address and port number to default
values.
For detailed information, read the Description of the primary accounting
command.
Related commands: key, radius scheme, state.
Example
To set the IP address of the second accounting server of RADIUS scheme, 3Com, to
10.110.1.1 and the UDP port 1813 to provide RADIUS accounting service, enter
the following:
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]radius scheme 3Com
[SW5500-radius-3Com]secondary accounting 10.110.1.1 1813
secondary
authentication
Syntax
secondary authentication
ip-address
[
port-number
]
undo secondary authentication
View
RADIUS Scheme View
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP addresses of
second authentication/authorization is at 0.0.0.0.
port-number: Specifies the UDP port number, ranging from 1 to 65535. By
default, the authentication/authorization service is provided via UDP 1812
Description
Use the secondary authentication command to configure the IP address and
port number for the second RADIUS authentication/authorization. Use the
undo
secondary authentication
command to restore the IP address and port number
to default values.
For detailed information, read the Description of the primary authentication
command.
Related commands: key, radius scheme, state.
To Next Page
Loading...
