462 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
Description
Use the info-center channel name command to rename a channel specified by
the
channel-number
as
channel-name.
. Using the undo info-center channel
command
, you can restore the channel name.
Note that the channel name cannot be duplicated.
Example
Rename channel 0 as execconsole.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center channel 0 name execconsole
info-center console
channel
Syntax
info-center console channel {
channel-number
|
channel-name
}
undo info-center console channel
View
System view
Parameter
channel-number:
Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name:
: Specify the channel name. The name can be channel6,
channel7, channel8, channel9, console, logbuffer, loghost, monitor,
snmpagent, trapbuffer.
Description
Use the info-center console channel command to configure the channel
through which the log information is output to the console.
By default, the Switch 5500G-EI does not output log information to the console.
This command takes effect only after system logging is started.
For the related commands, see info-center enable, display info-center.
Example
Configure to output log information to the console through channel 0.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]info-center console channel 0
info-center enable Syntax
info-center enable
undo info-center enable
To Next Page
Loading...
