VLAN Configuration Commands 83
undo port
interface_list
View
VLAN view
Parameter
interface_list
: list of Ethernet ports to be added to or deleted from a certain
VLAN, expressed as
interface_list
= {{
interface_type interface_num
|
interface_name
} [ to {
interface_type interface_num
|
interface_name
} ]
}
&<1-10>.
interface_type
is the interface type,
interface_num
is the interface number
and interface_name is the interface name. For their meanings and value range, see
the parameter of
Port in this document. The interface number after keyword to
must be larger than or equal to the port number before
to.
&<1-10>: Represents the repeatable times of parameters, 1 is the minimal and 10
is the maximal.
Description
Using the port command, you can add one port or one group of ports to a VLAN.
Using the
undo port command, you can cancel one port or one group of ports
from a VLAN.
You can add/delete trunk port and hybrid ports to/from a VLAN by port and undo
port commands in Ethernet Port View, but not in VLAN View.
For the related command, see display vlan.
Example
Add Ethernet1/0/2 through Ethernet1/0/4 to VLAN 2.
<SW5500>system-view
System View: return to User View with Ctrl+Z.
[SW5500]vlan2
[SW5500-vlan2]port ethernet1/0/2 to ethernet1/0/4
shutdown Syntax
shutdown
undo shutdown
View
VLAN Interface View
Parameter
None
Description
Use the shutdown command to disable the VLAN interface. Use the undo
shutdown
command to enable the VLAN interface.
To Next Page
Loading...
