54 CHAPTER 2: USING PORT COMMANDS
Loopback-detection is running
Detection interval time is 30 seconds
There is no port existing loopback link
display port Syntax
display port { hybrid | trunk }
View
All views
Parameter
hybrid: Enter to display the hybrid ports.
trunk: Enter to display the trunked ports.
Description
Use the display port hybrid command to view the ports whose link type is
hybrid. Use the
display port trunk command to view the ports whose link type
is trunk.
Example
To display the currently configured hybrid ports, enter the following:
<SW5500>display port hybrid
The details display in the following format:
The following hybrid ports exist:
GigabitEthernet1/0/1 GibabitEthernet1/0/2
This example indicates that the current configuration has two hybrid ports,
GigabitEthernet1/0/1 and GigabitEthernet1/0/2.
display unit Syntax
display unit
unit-id
interface
View
Any view
Parameter
unit-id:
Specifies Unit ID, ranging from 1 to 8.
Tab le 7 Output Description of the Display Loopback-detection Command
Field Description
Loopback-detection is running The Loopback-detection is enabled
Detection interval time is 30 seconds The detection interval is 30 seconds
There is no port existing loopback link No port is in the loopback state
To Next Page
Loading...
