3Com 5500G-EI - Display Ospf Routing

OSPF Configuration Commands 199
Example
To display information on the OSPF retransmission queue, enter the following:
<SW5500>display ospf retrans-queue
OSPF Process 200 with Router ID 103.160.1.1
The information displays in the following format:
The Router's Neighbors is
RouterID: 162.162.162.162 Address: 103.169.2.2
Interface: 103.169.2.5 Area: 0.0.0.1
Retrans list:
Type: ASE LSID:129.11.77.0 AdvRouter:103.160.1.1
Type: ASE LSID:129.11.108.0 AdvRouter:103.160.1.1
display ospf routing Syntax
display ospf [ process-id ] routing
View
All Views
Parameter
process-id : Enter process ID of OSPF, ranging from 1 to 65535. The command is
applied to all current OSPF processes if you do not specify a process ID.
Description
Use the display ospf routing command to view the information about the
OSPF routing table.
Example
To view information on the OSPF routing table, enter the following:
<SW5500>display ospf routing
OSPF Process 1 with Router ID 1.1.1.1
The information displays in the following format:
Routing tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
10.110.0.0/16 1 Net 10.110.10.1 1.1.1.1 0
10.10.0.0/16 1 Stub 10.10.0.1 3.3.3.3 0
Total Nets: 2
Intra Area: 2 Inter Area: 0 ASE: 0 NSSA: 0