3Com 5500G-EI - Display Rip Routing

162 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
Tab le 23 Description of the display rip interface Command
display rip routing Syntax
display rip routing
View
All views
Parameter
None
Description
Use the display rip routing command to view RIP routing information.
Example
To display rip routing information, enter the following:
<SW5500>display rip routing
RIP routing table: public net
Destination/Mask Cost NextHop Age SourceGateway
10.3.4.0/32 1 1.1.1.1 10s 1.1.1.1
11.0.0.0/8 1 1.1.1.1 10s 1.1.1.1
Tab le 24 Description of the display rip routing Command
Field Description
Address The IP address of the interface which runs RIP protocol
(you should enable the network segment in which this
address resides using the network command in RIP
protocol view)
Interface Name of the inteface which runs RIP protocol. The IP
address of this inteface corresponds to the IP address of
the Address field.
Ver Version of the RIP protocol running on an interface
Metrin/Out Cost of additional route which is added when sending or
receiving routes.
Input Allow/disallow the interface to receive RIP packets: on for
allow, off for disallow.
Output Allow/disallow the interface to send RIP packets: on for
allow, off for disallow.
Split-horizon The split-horizon is enabled or disabled: on for enabled,
off for disabled.
Field Description
Destination/Mask Length of the destination addresss/mask
Cost Route cost
NextHop Nexthop address of a route
Age Existing time of a route in the routing table (aging time)
SourceGateway Source gateway address. The route is learnt from the
gateway with this address.