Log Commands 457
View
Any View
Parameter
Use the display hwping command to view test results.
If a test group is specified using the arguments of administrator-name and
test-operation-tag , the system displays only the test result of the group. If not,
it displays the test results of all the test groups.
For the related command, see test-enable
Example
Display the test result of the test group whose administrator name is
‘administrator’ and operation tag is ‘jitter’.
[SW5500]display hwping result administrator icmp
Log Commands This section displays the logging options available on your Switch 5500G-EI.
display channel Syntax
display channel [
channel-number
|
channel-name
]
View
All views
Parameter
channel-number:
Channel number, ranging from 0 to 9, that is, the system has
ten channels.
channel-name:
Specify the channel name, the name can be console, monitor,
loghost, trapbuffer, logbuffer, snmpagent, channel6, channel7,
channel8, channel9.
Where console is channel 0, monitor is channel 1, loghost
is channel 2, trapbuffer is channel 3, logbuffer is channel 4 and snmpagent is
channel 5.
Description
Use the display channel command to display the details about the information
channel.
Without a parameter, the display channel command shows the configurations
of all the channels.
Example
Show details about the information channel 0.
<SW5500>display channel 0
channel number:0, channel name:console
MODU_ID NAME ENABLE LOG_LEVEL ENABLE TRAP_LEVEL ENABLE DEBUGGING_LEVEL
0xffff0000default Y warning Y debugging Y debugging
To Next Page
Loading...
