RMON Configuration Commands 499
[SW5500-GigabitEthernet1/0/1]undo rmon history 15
rmon prialarm Syntax
rmon prialarm
entry-number alarm-var
[
alarm-des
]
sampling-timer
{
delta | absolute | changeratio } rising-threshold
threshold-value1
event-entry1
falling-threshold
threshold-value2
event-entry2
entrytype { forever | cycle
cycle-period
} [ owner
text
]
undo rmon prialarm
entry-number
View
System view
Parameter
entry-number:
Specifies the entry number, ranging from 1 to 65535.
alarm-var:
Specifies the alarm variable, which can be an arithmetic expression of
several integer MIB node instances. The node can be OID in dotted notation.
alarm-des:
Specifies the alarm description with a length ranging from 1-256;
sampling-timer:
Sets the sampling interval, ranging from 10 to 65535 and
measured in seconds.
delta | absolute | changeratio: Specifies the sampling type as delta ratio,
absolute ratio or change ratio.
threshold-value1:
Rising threshold value, specified with a number greater than
0.
event-entry1:
Corresponding event number to the upper limit threshold value,
ranging from 0 to 65535.
threshold-value2:
Falling threshold value, specified with a number greater than
0.
event-entry2:
Event number corresponding to the falling threshold, ranging
from 0 to 65535.
forever | cycle
cycle-period:
Specifies the type of the alarm instance line.
cycle-period
specifies the functional cycle of the instance.
owner
text
: Specifies the creator of the line. Length of the character string
ranges from 1 to 127.
Description
Use the rmon prialarm command to add an entry to the extended RMON alarm
table. Use the
undo rmon prialarm command to delete an entry from the
extended RMON alarm table.
The number of instances can be created in the table depends on the hardware
resource of the product.
To Next Page
Loading...
