OSPF Configuration Commands 189
display ospf cumulative Syntax
display ospf [
process-id
] cumulative
View
All Views
Parameter
process-id
Enter process ID of OSPF, ranging from 1 to 65535. The command is
applied to all current OSPF processes if you do not specify a process ID.
Description
Use the display ospf cumulative command to view the OSPF cumulative
information.
Example
To display the OSPF cumulative information, enter the following:
<SW5500>display ospf cumulative
OSPF Process 1 with Router ID 1.1.1.1
The information displays in the following format:
Cumulations
IO Statistics
Type Input Output
Hello 225 437
DB Description 78 86
Link-State Req 18 18
Link-State Update 48 53
Link-State Ack 25 21
ASE: 1 Checksum Sum: FCAF
LSAs originated by this router
Router: 50 SumNet: 40SumASB: 2
LSAs Originated: 92 LSAs Received: 33
Area 0.0.00.0:
Neighbors: 1 Interfaces: 1
Spf: 54 Checksum Sum F020
rtr: 2 net: 0 sumasb: 0 sumnet: 1
Area 0.0.0.1:
Neighbors: 0 Interfaces: 1
Spf: 19 Checksum Sum 14EAD
rtr: 1 net: 0sumasb: 1sumnet: 1
Routing Table:
Intra Area: 2 Inter Area: 0ASE: 1
Timers OSPF timers:
■ Hello — Interval of hello packets
■ Dead — Interval of dead neighbors
■ Poll — Interval of poll
■ Retransmit — Interval of retransmitting LSAs
■ Transmit delay — Delay time of transmitting LSAs
Table 27 Output Description of the display ospf brief Command
To Next Page
Loading...
