3Com 5500G-EI - Debugging; Display Diagnostic-Information

448 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
debugging Syntax
debugging module-name [ debugging-option ]
undo debugging { all | module-name [ debugging-option ] }
View
User view
Parameter
all: Disable all the debugging.
module-name: Specify the module name.
debugging-option: Debugging option.
Description
Use the debugging command to enable the system debugging. Use the undo
debugging
command to disable the system debugging.
By default, all the debugging processes are disabled.
The Switch provides various kinds of debugging functions for technical support
personnel and experienced maintenance staff to troubleshoot the network.
Enabling the debugging will generate a large amount of debugging information
and decrease the system efficiency. If the the
debugging all command is used, it
will adversely affect the operational performance of the network. Use the
undo
debugging all
command to disable all debugging.
For the related commands, see display debugging.
Example
Enable IP Packet debugging.
<SW5500>debugging ip packet
IP packet debugging switch is on.
display
diagnostic-information
Syntax
display diagnostic-information
View
All views
Parameter
None
Description
Use the display diagnostic-information command to view the configuration
information on all currently running modules. This information helps you to
monitor and troubleshoot your Switch 5500G-EI.